Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi all,I have a setup as below. The server is of a HP blade enclosure. Both the blade switch are connected to two different 2Ks with port-channel.( I have not shown that part in the drawing. When i tried to ping from one of the Blade server from the...
Hi all,I have a small doubt in applying bpdu filter on the trunk ports connecting HP blade switches(again cisco switches) in my data center. the above diagram can be seen for reference. I am not able to find out a proper document saying anything nega...
Hi,I have upgaded the ACS 3.3.1 for windows server to 4.2. Everything went fine but the local database is not working.The CD is an upgrade kit from 3.x to 4.2 on windows. I tried to install directly the 4.2 I was able to install but integration with ...
Hi All,There are 3 switces stacked & spanning-tree root primary for one vlan is configured on it. One of the stack port showing as the STP inconsistance state.Name Interface Inconsistency-------------------- -------------...
Hi,I have nexus 7010 running ospf. When I traceroute from one of the far remote sites (6hops away) I cant see the nexus as a hop. Where as from another site which is 5 hops away I can see it.Anybody have any idea why i cant see it. Is there anythin...
Hi Lucien,Till I couldnt get a chance to check the show outputs of the 2248s.But I have one more question in the 7K. We have connected a link on the 7K on the 32x10g SFP+.Everytime we do shut & no shut the module(port) disables. Once we remove the SF...
Hi Lucien,It is very nice here from you. I gone through your presentation. It is nice. But sorry I didnt mention about the 2K. It is 2248. We had 2148 earlier but as we need to terminate the blade switches on the 2K with multiple uplinks bundled(in c...
Jon,Thanks for your query. the reason behind is that the blade switches are not under our control. so in case any misconfiguration at the blade switch level it should not reflect to the whole data center consisting of around 20 4948 switches & more ...
Hi Javier,First of all I was facing a problem of restoring the old database of 3.3 to 4.2. Somehow I overcame that issue by following the below steps. Now local authentication is working fine but AD/other External database authentication is not worki...
Hi Javier,Actualy non of the authentication is working after upgrading neither local nor external. But if we install the 4.2 directly atleast local database authentication is working fine but not windows database. I am going to see the logs & will le...
