Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for
- Cisco Community
- :
- About V K Moorthy
Stats
Member since
10-03-2010
120
Posts
81
Helpful
16
Solutions
06-23-2016
05:07 AM
No GLC-SX-MMD is not supported by SMB switches.
pls check below link:
http://www.cisco.com/c/en/us/products/collateral/switches/small-business-smart-switches/data_sheet_c78-610061.html
... View more
06-21-2016
03:21 AM
Hi,
Can you advise if the SG550XG-8F8T-K9-NA can be stacked with the SG500X-48-k9-NA?
Answer for this question is: NO
Yes , SG550XG-8F8T-K9-NA is supported for stacking with same family switch models with any SG550XG.
regards
... View more
04-22-2015
06:27 PM
Hi, Kindly check whether switch gateway(192.168.99.X- sub-net) is reachable or not from department subnet(10.10.10.X) regards
... View more
04-07-2015
12:03 AM
Hi, Dont use VLAN 100 for Cameras .Since its default vlan for voice in SG300.Try to create different VALN XX (other than 1 and 100). Configure port as below:(where cameras are connected) conf#int vlan XX conf-int#switchport mode access vlan xx regards Moorthy
... View more
04-01-2015
08:05 PM
Hi, Kindly create the TAC case to get support over phone:(Need to check the device over remote) Out TAC contact details:(Link provided) http://www.cisco.com/c/en/us/support/web/tsd-cisco-small-business-support-center-contacts.html regards
... View more
03-25-2015
01:52 AM
Your RV082 is ver 1/2 hardware .But this firmware RV0XX-v4.2.3.03-20140319-code.bin only supported by RV082 ver 3 hardware.
... View more
03-18-2015
08:29 PM
Hi, Try to save the configuration as below:(GUI) Running config-----------> Backup Config Backup config --------------> Startup Config Save configuration and Reboot .
... View more
03-15-2015
09:44 PM
Hi, Try to upgrade the bootcode : sx300_fw-13506.rfb and upgrade the firmware to 1.4.0.88.Check whether DHCP pools are working fine.
... View more
03-15-2015
08:24 PM
Hi, step 1: Go to GUI Menu; Smartport------>Smartport type settings---->Select IP phone+ Desktop edit (refer the 11.jpg) Step2: Select port type: IP phone + Desktop-----> change the Paramenter Value 1 ( Vlan 1 to Vlan 35)-Refer 22.jpg regards Moorthy
... View more
Created by
V K Moorthy
in Small Business Switches
in Small Business Switches
03-11-2015
08:51 PM
03-11-2015
08:51 PM
HI, Use the below Link: https://supportforums.cisco.com/discussion/12286911/sg300-firmware-upgrade-copy-illegal-software-format You need to do same for SG200 switch
... View more
03-09-2015
10:55 PM
Hi, Check the below link: https://supportforums.cisco.com/discussion/12396466/firmware-update-cisco-sf300-using-cli regards Moorthy
... View more
03-05-2015
04:54 PM
Hi, Add the static route in switch for internet.By adding this configuration internet will start work.Kindly give the show tech details to review your DHCP configuration on switch. regards Moorthy
... View more
02-24-2015
05:06 PM
Hi, Looks like hardware failure. Kindly raise the service request with TAC team. TAC contact details as below:(use below link) http://www.cisco.com/c/en/us/support/web/tsd-cisco-small-business-support-center-contacts.html regards Moorthy
... View more
02-24-2015
12:15 AM
Hi, SG220 is the advance switch compare with SG200 switch. Many added options are in SG220: 1.CLI supported 2.Telnet 3.SSL 4.MSTP for more details see the below datasheets: SG220: http://www.cisco.com/c/en/us/products/collateral/switches/small-business-220-series-smart-plus-switches/datasheet-c78-731284.html SG200: http://www.cisco.com/c/en/us/products/collateral/switches/small-business-100-series-unmanaged-switches/data_sheet_c78-634369.html regards Moorthy
... View more
02-19-2015
04:51 PM
Hi, Only one option can be configured either Load balancing or smart link backup. Login to Router: Under menu; System Management---> Dual WAN----->choose the option smart-Link backup/Load-balance regards Moorthy.
... View more
06-23-2016
No GLC-SX-MMD is not supported by SMB switches. pls check below link:
http://www.cisco.com/c/en/us/p...
06-21-2016
Hi, Can you advise if the SG550XG-8F8T-K9-NA can be stacked with the
SG500X-48-k9-NA? Answer for thi...
04-22-2015
Hi, Kindly check whether switch gateway(192.168.99.X- sub-net) is
reachable or not from department s...
04-07-2015
Hi, Dont use VLAN 100 for Cameras .Since its default vlan for voice in
SG300.Try to create different...
04-01-2015
Hi, Kindly create the TAC case to get support over phone:(Need to check
the device over remote) Out ...
03-25-2015
Your RV082 is ver 1/2 hardware .But this firmware
RV0XX-v4.2.3.03-20140319-code.bin only supported b...
03-18-2015
Hi, Try to save the configuration as below:(GUI) Running
config-----------> Backup Config Backup con...
03-15-2015
Hi, Try to upgrade the bootcode :sx300_fw-13506.rfb and upgrade the
firmware to 1.4.0.88.Check wheth...
03-15-2015
Hi, step 1:Go to GUI Menu;Smartport------>Smartport type
settings---->Select IP phone+ Desktop edit ...
03-11-2015
HI, Use the below Link:
https://supportforums.cisco.com/discussion/12286911/sg300-firmware-upgrade-c...
03-09-2015
Hi, Check the below link:
https://supportforums.cisco.com/discussion/12396466/firmware-update-cisco-...
03-05-2015
Hi, Add the static route in switch for internet.By adding this
configuration internet will start wor...
02-24-2015
Hi,Looks like hardware failure.Kindly raise the service request with TAC
team.TAC contact details as...
02-24-2015
Hi, SG220 is the advance switch compare with SG200 switch.Many added
options are in SG220:1.CLI supp...
Public Statistics
| Date Registered | 10-03-2010 11:26 PM |
| Date Last Visited | 02-16-2018 03:52 AM |
| Total Messages Posted | 120 |
| Total Helpful Votes Received | 81 |
Helpful Votes From
