Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Greetings to all, yesterday I was doing a test on 2 cisco 2950 and 3750 switches and I got some worrying results ... when I transfer data from one PC to another the maximum bandwidth achieved is 11 mbps, it is important indicate that the switches hav...
I'm wondering, how can we determine the model of router we should use in any circumstances, since we have the 1800 series, the 2800 series and others with higher capacity. How should I know which one to install instead of the other. How can I make a ...
Hi, i need to erase de configuration file in 1131 AG-A K9. is an Autonumos series. and i can not set any configuration unless i erase the the NVRAM. i Have try loooking for any troubble shouting guide but nothign helps. any information it will be ap...
Hi, i need to configure a ASA5510-SEC-BUN-K9 in my office. i need to know if there is an configuration tool, or every thing is done by cli. If there is a configuration tool, where can i download information about it, and if is only by cli where can i...
Is this switch PoE? If the answer is positive, there may be a short in one of the ports and this is exceeding the consumption of the power source and due to protection it is turned off.if you can and you dare:1) Carefully review the switch's ethernet...
Greetings .. the best way to disable DTP on a cisco port is:switchport mode accessswitchport nonegotiateand then.....switchport access vlan 20Access ports do not handle DTP.Recall that DTP is a proprietary protocol for trunk handling .. and will alwa...
My Answres 1. Which interfaces do PC’s A and B connect to on the C3750? Im using varius ports on the switch. 2. Do both PC’s reside in the same VLAN?Yes 3. What are the associated IP addresses and subnet of both PC’s?192.168.0.x / 24 I would sugge...
HWB-SW-001#HWB-SW-001#show interfaces | inc ^[A-Z]|duplex|dropsVlan1 is up, line protocol is up Input queue: 0/75/0/0 (size/max/drops/flushes); Total output drops: 0Vlan100 is up, line protocol is up Input queue: 0/75/0/0 (size/max/drops/flushes); ...
Here it is HWB-SW-001#HWB-SW-001#show interfaces | inc ^[A-Z]|duplex|dropsVlan1 is up, line protocol is up Input queue: 0/75/0/0 (size/max/drops/flushes); Total output drops: 0Vlan100 is up, line protocol is up Input queue: 0/75/0/0 (size/max/drop...
