Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi, i got a BGP LAN and need to connect serveral L3 OSPF devices with Client-Networks. For the incoming routes i do a redistribution from OSPF (Client-Networks) to BGP and 50% of the work is done. If someone creates a new VNI the LAN automatically le...
Hi,i have a 3750 with 12.2.55SE7 and he has some output queue 3 dropps at threashold 3. As far as i remember the threshold three is a static parameter on the switch. In fact that there is only a telephone located at this port it is not easy to explai...
Hi together,i've tried to set a 1242ag into bridge mode for checking the wireless-mesh function. After that switch the ap won't connect to the wlc anymore. Normally the AP should connect to the WLC as a RAP (AP with connection to the LAN) and providi...
Hi together,i want to ask you for a good way to solve a problem:One of my friends has an AS connected to two different providers. The routers have the full BGB Table and the routingtable prefers the provider that is closest to the destination somewhe...
Hi,it was too long ago with MLS and MSFC .. so i forgot the answer Starting Scenario:Two 6500/Sup720 "Routers" with HSRP about 20 VLANs and three more 6500/Sup720 "Switches" only in Layer 2 with the same VLANs and redundant Uplinks to the "Routers"T...
Here is the diagram. With the Loopback in Area0 "Workaround" the LSA 3 default route comes down to the Router R3 two Times (sourced R1,R2) with STUB no-autosummary. R1/R2 Routers won't learn any R3 Routes excapt the R2- he learns the default route ad...
Thanks! 1) My Questions: How can i "create" area 0/backbone locally on the BGP/OSPF Router and configure the Downlink in a nssa with default originate ? Currently i have only one Zone and one Interface where i can play with because i got BGP on the C...
Hi,right, but i cleared those counters In this case the show command is starting with counting on 0 -> Q2 (is Q3 in reallive) so were hitting here the signalling queue not the data-queue.The telephone is located in the normal VLAN - so broadcasts an...
