Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I manually disabled a client in the monitor>clients and when I check in the WLC's CLI the client is excluded. Now I can't find a way to enable the client using either CLI or GUI.
Hello every body I am studying for CCNP and have a problem with configuring RSPAN. I have 2 3550 switches that I wanna use one to connect the source to it and another one for destination. To connect these 2 switches I am using a home Linksys router....
I just don't know why should use "aaa authentication enable default enable" if you are not using AAA. This happened to me today that even with local username and password defined and with login local command for line vty, still I got that error messa...
After testing different command in CLI I found the command which is (Cisco Controller) >config exclusionlist delete < MAC add > but still I don't know how to do it through GUI
I can see that this post is 4 years old but just for people like me who may have same question in the future. This is not possible and the reason is explained as it is the client who pick the AP which has the best signal compare to others. If there i...
In the WLC web interface, choose the wireless tab then in the page showing list of APs connected to the WLC scroll the page to the left ( so you will be able to see the rest of the page on the right side ). In the page there is a "No of Clients" whic...
