nguyen
Community Member
Member since ‎04-08-2006
‎08-18-2017
Awards
No awards available to display

User Statistics

  • 13 Posts
  • 0 Solutions
  • 0 Helpful votes Given
  • 0 Helpful votes Received
Recent Badges
Certifications
No certifications available to display

User Activity

Hi,I have a 2811 router with 2 E1 Pri and connected to a 4.1 CCM.My understanding is that the link between CCM and the PRI is direct through the binding belowinterface Serial0/0/0:15 no ip address encapsulation hdlc isdn switch-type primary-net5 isdn...
Here is my issue.I have two VWIC cards on a 2811 going to 2 providers.One E1 is going down with errors. Line code violations blablabla, and sometime just by chaging the time on the CCM.Do I need to configure clock source internal on both controller o...
On a 2811 acting as gateways for CCM 4.1 I have 2 Wic cards for 2 E1, with following conf :network-clock-participate wic 0network-clock-participate wic 1controller E1 0/0/0 framing NO-CRC4 pri-group timeslots 1-31 service mgcp!controller E1 0/1/0 fra...
I basically followed the config example of cisco in :http://www.cisco.com/en/US/products/hw/vpndevc/ps2030/products_configuration_example09186a0080094498.shtmlit works fine.my pb is:the remote site has a 2Mbps line but once the tunnel is up, even wit...
I used the almost same config ashttp://www.cisco.com/en/US/products/hw/vpndevc/ps2030/products_configuration_example09186a0080094498.shtmlIOS router 12.0(7)T on 2621 (8MB flash)PIX 515 6.2the tunnel works fine during lifetime of 3600 seconds, then ju...
Community Statistics
Member Since ‎04-08-2006 01:31 PM
Date Last Visited ‎08-18-2017 03:55 AM
Posts 13