About kneber

kneber · 07-08-2005

I have a working VPN tunnel, both with and without a crypto card. My problem is that with crypto card installed, the MTU size in the crypto have been changed to 0 vs. without crypto card the MTU size is 1492. With the crypto card all traffic with DF ...

kneber · 10-04-2008

Can you ping/get to other networks outside local sub-net? Have you checked routing tables?1. On VLAN32's gateway: check that the routing table contains the default route, and that nexit hop is what you expect it to be.2. On other routers: check that ...

kneber · 06-23-2006

Under is the result from "Output Interpreter"(https://www.cisco.com/cgi-bin/Support/OutputInterpreter/home.pl)(Start)ERROR MESSAGE NOTIFICATIONS (if any)%SYS-3-TIMERNEG: Cannot start timer ([hex]) with negative offset ([dec]).Explanation: : An intern...

kneber · 06-23-2006

Hi,I would not disable spanning tree. If (but not likely in this network) multicast from STP is impactive performance, you can reduce the number if spanning tree instances to one or two by using MST instead of Per Vlan STP (one per vlan). This should...

kneber · 06-14-2006

Can you post the config? It would be easier to show what to do.Richard

kneber · 06-14-2006

Hi,This command is suppose to allow for source and destination IP loadbalancing on a etherchannel.Router(config)#port-channel load-balance src-dst-ipUseRouter# show etherchannel load-balanceto view what type loadbalancing is in use.Richard

Member Since	‎07-08-2005 04:40 AM
Date Last Visited
Posts	7
Total Helpful Votes Received	3

User Statistics

User Activity

MTU size of 0 with NM-VPN/MP card installed

Re: Strange network issue

Re: logging router c2600

Re: STP

Re: Connecting 2 routers to be used as fallover

Re: Etherchannel issue on tunnel