Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi everyone - I have a question on how to implement load balancing between cisco routers. Here's the situation. We have a stack of 3750 switches connected to a 3845 router with dual T3's. This router will be connected to a MPLS cloud. How can I imple...
Hello everyone - I have a design question that involves a Cisco ASA firewalls (2 actually, one of them is for failover), a stack of 3750 switches and a Cisco 3845 router. I am a little confused about how the equipment should be connected for optimal ...
Hi folks -I recently purchased Cisco 1131AG Access Points, which have the ability to create VLAN's. I want to provide staff with wireless access, and also the guests with wireless access. Staff needs access to all network resources, and public needs ...
Hello folks -We have a Cisco PIX 515E (6.3) that users VPN into. The PIX is at our main site, and we have 2 branch sites connected to the main site via point-2-point leased lines. Our main site address is 10.0.0./24, and one of our branch sites addre...
Ok, to make things simpler, lets assume I have a single 3750 switch which needs 2 VLAN's on it. The respective VLAN IP addresses on the 3750 will be the default gateway for the servers in those two respective vlan's. The 3750 switch will need to be c...
Hi Kamal -I am attaching the config file for the PIX and the router at the branch site. I still can't figure out why VPn clients are unable to connect to the branch office. I read somewhere that PIX will not let you send and receive traffic on the sa...
