Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have an RV320 set up for a customer but I guess I got the instructions wrong for port forwarding. What they want, and what the old router did was:
External port 45069 should be mapped to Internal port 5069 for IP 192.168.0.8
External port 44222 s...
I am going to attempt to segment a small LAN with three VLANs. I will have one VLAN for data, another for security cameras, and a third for public Internet access. I have a good understanding of how to do this but one thing I am not sure of. Do I ...
I am trying to create a Gateway-to-Gateway VPN tunnel and failing at all turns. I could really use some help. I posted to this forum a couple of weeks ago looking for directions for configuring an RV180 to an RV180. I discovered the RV180 was disc...
I have a Cisco RV180 small business router. I am trying to make a set of outbound rules to block SMTP traffic on all devices except the Exchange mail server located at 192.168.16.3I have attached pictures of the two rules.Outbound rule #1 has priori...
Glenn, thanks for the reply. The solution was to use Port Address Translation and to be sure not to also be using Port Forwarding as one seems to cancel the other.
Cheers!
Thank you. So to confirm using your example, if the router is on port 1 on vlan 10 with a default gateway address of 192.168.10.1, all the computers on vlan 30 can get out on the Internet if port 1 is a member of vlan 30?
Mark, thank you for your reply. Just to confirm with you, the remote router is the RV320. There is a selection for IP only but I do not have a static IP at the remote side. However, I do have a dyndns address that I have not been able to get worki...
Update:There does not appear to be a provision for a dynamic IP for the remote on the RV180. I used FQDN and put in xxxx.dyndns.orgOn the RV320 there is no FQDN selection only, it is Dynamic IP + FQDN. I'm getting lost
I am having a lot of trouble with my configuration. Would you take a look at my thread located here:https://supportforums.cisco.com/discussion/12581466/vpn-help-rv180-rv320
