Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have seventy-some connections that we are trying to move from old legacy DEC equipment to various Cisco terminal servers. These are "reverse" connections that are established by a network host via LAT. The connections remain up indefinitely, and ...
I have a 3845 router that has a couple of interfaces generating a much larger amount of traffic than they should be. Is there a way to get a list of the IPs or MAC addresses, and how many octets they send/receive? The only way I've figured so far w...
I have a number of Catalyst 65xx switches running CATOS. The default logging level (5) generates the following types of messages when a connected host powers up and down:2007 Feb 19 13:42:36 AKST -09:00 %ETHC-5-PORTFROMSTP:Port 3/45 left bridge port...
I have a situation where I need members of the same group to have different TACACS command authorization depending upon the device that they are logged into. In the old Unix software (v2.3 I think it is), this was easy to implement. However, I have...
Old setup. CiscoSecure ACS v3.x Windows server also has the RSA/ACE agent that queries a second server for SecurID authentication C3745 and a PIX used for inbound remote access Users access w/Cisco Systems VPN Client Works greatNew setup. CiscoSecure...
I had tried lat host-delay as well, but thanks anyway. I also tried filing w/the TAC, but they didn't have any ideas either. In the end, after weeks of trying, we finally got a response Tuesday out of the vendor that created the software to begin w...
This depends on your DHCP server. I haven't read the RFC recently, but I do not believe that it is defined. I have run two different DHCP servers and have always had to tell the server if a physical interface had multiple logical networks (shared-n...
Thank you much for the reply and link, and I apologize for my tardiness in responding. I had tried a couple of times w/o success to leave the AAA server in the default group, but after reading the white paper and your response, I decided that I prob...
