Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi.In a SCE2020 with version 3.5.5, we have can not establish more than 10 simultaneous connections. We obtain a message 'unable to open connections - max number of sessions exceeded'.We use the SCE API for connect to the SCE.Is limited the SCE to 10...
Hi.We have a problem with the XENPAK-10G-LR that doesn't switch off the lasser in shutdown state, installed in 6509 with WS-X6704-10GE. The other side of the connection doesn't detects the shut.I have checked that the X2-10G-LR disables the light, th...
Hi.We have a problem with the connection of several CPEs (non-cisco).these CPEs sends a PADR with a size of 129 bytes, then our concentrator (7200) doesn't accept the connection:Jan 7 09:27:25.325: [818]PPPoE 397: Service request sent to SSS Jan ...
Hi.We have the same IP Addresses in different PEs. These addreses are not redistributed by routing. These IPs belongs to loopbacks that we use for communication with CEs.The problem is that the P routers receive these addresses by LDP.Then in the P r...
Hi.I have configured a VPN with radius authenticacion. The radius send the IP,the forwarding vrf and the framed route.The framed-route is inserted directly by the PE in the vrf routing table.I want to inject a route that must not included int the vrf...
We tried this method yesterday (reinitiate rpc-adapter), but when we continue with the application (that open several sessions simultaneously sith SCE API), the problem happens again.We are going to check is with the SM we have the same problem.Thank...
Thanks Shelley.I have not found any document or bug that describe this limit. Do you know a public document that describe this limit?Do you know if any version supports more than 10 sessions? Is a limitation for SCE8000 too?Thanks and regards.
Hi.We have had the same problem in 7600 (12.2SR) and 6500 (12.2SX).I checked the realase notes and field notices, without results.As a workaround, you can activate 'ethernet oam' to check that link is really up (if the other box supports it).Regards....
Hi.It's not a problem with the MTU (we have configured the MTU as 1492, and we adjust the MSS).The problem happens at the pppoe client session initiation (PADI,PADO,PADR,PADS).The PADS (that a CPE send) seems to be bigger than the supported size. Thi...
