Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi guys, I got this configuration question which I am puzzled. Refer to the attachment. I got 2 L3 switches and the requirement is that based on the vlan tagged from L2 switch, the respective L3 switch should handle the vlan routing. And both L3 swit...
I am facing a routing problem. Refer to the attached document for network topology.On the C2811 router (IOS 12.4), I can ping to any local VLAN segments. But I can't ping to remote 10.10.31.x/24., other than .254 host. But on the C1841 router itself,...
Good day, folks.When I plug in a console cable to a Sup 2 engine on a Cat 6509, the screen shows I am in ROM monitor mode (rommon 1> )! And the switch load shot up to 30% instantly. A reboot was necessary by then. Online diagnostics test show the har...
I do further troubelshooting and realised the remote router can't access the HQ switch's uplink port, which link back to core switch. But I can't find any fault in the core switch.
