Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,I have a very difficult question that I need help.The network 2 needs communicate with the network 1, but the networks are the same. The solution is NAT subnet to subnet.I only can configure the router B.The network 2 knows the network 1 as 172.16...
helloI have a question about N5k Peer keepalive path. I can do it through mgmt0 interfaces with a crossover cable to connect the two nexus? Or is not recommendedgreetings to you all
Hello I have a C2960-24PC-L which has a very high occupancy of the processor memory. I've used version 15.0SE 15.0SE2 and now 15.0SE3 and the problem seems to persist. Head Total(b) Used(b) Free(b) Lowest(b) Largest(b)Pro...
HelloI have some doubts about VM-FEX, I can only take advantage of this solution with Cisco UCS servers, right? If I have servers from other vendors, the solution is the Cisco Nexus 1000V, right? I need a solution to have more control in a new VMware...
Hi, I have two servers to be balanced on port 80, but I received a request, from the team that makes the maintenance of these servers, to when anyone introduce a specific url, the access is always made through the same server.This can be done? I have...
I realize your point of view. The solution I presented was to avoid spending upstream ports on the switch, but really makes sense to use the door to management since they are separate from everything else. thank you
I put the "sh processes cpu" above. No interface have relevant traffic at this time, for example, the uplink:5 minute input rate 80000 bits / sec, 21 packets / sec 5 minute output rate 11000 bits / sec, 8 packets / sec thanks
