Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
The setup is simply this: Verizon D-Link DSL Modem/Router in bridge mode (ethernet ATM bridge) to ASA5505 to PCs.The PCs get an IP address, default gateway, DNS server IPs from ASA5505.Win 7 and XP Pro PCs get IPs, but message warning "No Internet Ac...
Hi,We have 2 internet connections- one for production and one as a backup. The backup connection will be used for allowing guest visitors on a wireless network that is on a seperate VLAN.We have the following networks:VLAN 1 production, 192.168.1.0V...
Hi,I want to split the usage of the AP so that visitors are on their own wireless connnection and VLAN.We have 2 WAP4410N APs. One AP acts as a repeater for the another AP.They are both in 4.0.4.2 firmware.We are using WPA2 RADIUS authentication, an...
Hi All,We have 2 WAP4410N APs. One set as the main AP and the other to repeat the AP signal. The repeater was previously set in client/repeater AP mode. It was reported to me that a wireless user at a company across the street was able to connect ...
Hi All,I have a question or 2 about 5505 Interfaces and how they work with VLANs.I set IPs to Interf VLAN1 and 2 as inside and outside, respectively.Figured out that VLAN2 should be set via switchport access command.Ran a No Shut on all interfaces, i...
Thank you for the reply.As a temporary workaround, I move the guest wireless to the .100.0 network, just so we can get the ball rolling for visiting guests.We can change the SMC modem/router to a bridge for passing data only. Need the ISP to make t...
"it could be sending the request to the internet without NAT"I see, so when the response comes back, it doesn't know where the request came from?It does have 1 to 1 NAT capabilities and we are using it. I imagine that it can do NAT on an internet re...
Robert,The solution worked fine. The AP setup a trunk, I set the trunk on the Cisco 2970 and with some other configuration, the wireless client gets an IP, DFGW and DNS info from a different network.I haven't put the second AP on the same SSID becau...
