About harisapkota123

harisapkota123 · 07-21-2014

Hi Everyone!I have a scenario of 3 PE routers with full mesh VPLS Pseudo-wires configured over it. If you look into the design, I have connected two switches Sw1 and Sw2 with the PEs R2 and R3 respectively. Considering that the VPLS cloud is operatin...

harisapkota123 · 02-19-2014

Hi,I have a network as shown below. Where, Sw1 is running R-PVST and other switches Sw2,Sw3&Sw4 are aunning MSTP. Sw2 is the IST and CIST root. The issue is, whenever I try to ping from Sw1 to the switches running MSTP, I can't ping without allowing ...

QoS for individual users · 01-27-2014

Hello all,I'm trying to apply QoS in my LAN network in order to give dedicated bandwidth to 100 users if any user is trying to go to www.youtube.com. For rest of the traffic, I don't need to dedicate the amount of bandwidth.As per my solution, I can ...

harisapkota123 · 06-11-2012

Dear All,I have three routers R1-R2-R3 connected in a network..R1 has the following configuration:interface Loopback0 ip address 10.168.246.11 255.255.255.255! interface GigabitEthernet0/0 ip address 10.168.254.4 255.255.255.0 duplex auto spe...

harisapkota123 · 05-19-2012

Dear All,I have some Cisco 2651 routers, I was trying to implement MPLS on those routers, Can i accomplish this upgrading newer IOS version? Appreciate if someone could advise and provide me the link to download the supported IOS.Thanks,

harisapkota123 · 09-26-2014

Hi Dorkyninja,Thanks for your answer!Your answer has been very useful for me to solve the issues with ASA Anyconnect VPN. Thanks again!

harisapkota123 · 02-20-2014

Hello Peter,Thanks for the nice explanation.I was running into the same kind of issue. Now, it's clear to me. I just want to share my test result since i'm also in the migration phase from R-PVST to MST.I was able to see "Root Inc/PVST Inc" whenever ...

harisapkota123 · 02-20-2014

Hi,Thanks for the reply!Actually, I have tested it again and found an intersting thing.I had read somewhere that if any MST region receives superior BPDU from the PVST, the port goes into Root Inconsistent mode. But, the intersting part is, if I allo...

harisapkota123 · 02-20-2014

The switches I have are Cisco2950 & Cisco2970. IOS Version is : c2950-i6k2l2q4-mz.121-22.EA12c2970-lanbasek9-mz.122-44.SE6Thanks!

QoS for individual users · 01-27-2014

Daniel,Thanks for the quick reply!It's Cisco1841 router with IOS image 12.4. I'm just not able to understand how to minimize the configuration of ACL & class-map. Thanks!

Member Since	‎04-27-2010 12:19 AM
Date Last Visited	‎02-14-2021 10:08 PM
Posts	52

User Statistics

User Activity

STP over VPLS

MSTP vs RPVST

QoS for individual users

redistributing bgp into ospf

regarding MPLS

Hi Dorkyninja,Thanks for your

Migrating from Rapid-PVST+ to MST

Re: MSTP vs RPVST

Re: MSTP vs RPVST

QoS for individual users