Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,I am stuck with situation, where I need to get the autonomous AP to just authenticate with ISE EAP-TLS, is it possible?so far I am not able to get it working, and ISE authenticate logs says that EAP method is not allowed in allowed-protocol, at th...
probably you need to enable the keepalive on the serial interfaces. keepalive is the frequency at which the Cisco IOS software sends messages to itself (Ethernet and Token Ring) or to the other end (serial and tunnel), to ensure that a network interf...
probably you need to enable the keepalive on the serial interfaces.keepalive is the frequency at which the Cisco IOS software sends messages to itself (Ethernet and Token Ring) or to the other end (serial and tunnel), to ensure that a network interfa...
It is not claer wht you exctly want to achieveAFAI can understand that you want to NAT all traffic comning from 198.20.10.0 network and and you specifically want any traffic from source 198.20.10.121 will not be natted by your router.ip nat pool ras ...
Hi,This document describes how to recover the password and the enable secret passwords:- http://www.cisco.com/warp/public/474/pswdrec_2600.shtml#procedure
Hi All,Plz correct me if I mentioned something wrong considering the Checkpoint as VPN end points.In your router configuartion pasted above, It shows that you only defined the access-list but you are not applying it to any interface. What I would sug...
