Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Dear all,I have an issue with a desktop supplier:The desktop's integral wifi b/g adapter routinely drops about four out a 1000 1000-byte pings from the next-hop gateway through an ap1130 a/g. (for the record, plenty of bandwidth, resources, no proble...
I have a AIR-LAP1131AG-A-K9 configured with autonomous IOS and power injector.It stays up for 5-8 minutes then reboots.I swapped out the ap at the far end of the Cat5 drop, but the problem persists. The ap, however, stayed up all night when directl...
Hi,I have several 2950's and 3550's hung on trunks off a common 3550 EMI.Configuring switchport protected on interfaces disables L2 communications between these interfaces on the same switch.Can anyone tell me a sane/simple way to disable L2 between ...
Dear all,I configured an 1130 autonomous ap with an open guest ssid and another unadvertized WEP enabled ssid.I could not get Windows XP to successfully associate and connect in any combination of desktop settings and ap configuration.Everything work...
Thank you both for the helpful information for the snmp ifMIB.Specifically, I need to find out when the show interface counters for input and output packets overflow. These two apparently do not correspond to any ifMIB variables.Thanks again.
Hi, Johannes,As you can see I did not get a response. I ran into a problem with the scsi raid and wound up doing a quick and dirty install using an internal 80Gb SATA with just a boot and root partitions.I'm running my AP's autonmously and have not ...
SOLVED: It looks like a progressively failing power supply caused this. It now outputs ~35vdc compared to its rating of 48vdc. Before it got to this point it could drive POE over patch cables in a comms closet but could not handle a 137' drop.At the...
Rob, et al:I have distinct ssid's, vlan's, bridge-group's, and dot11radio{0,1} sub interfaces on autonomous AP's dot1q trunked to a l3 switch.I applied bridge-group n port-protected to dot11radio sub-interface used by the guest ssid. This does seem t...
