Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I am trying to throttle a single port on a Cisco 3560 Cat swith running Cisco IOS Software, C3560 Software (C3560-IPSERVICES-M), Version 12.2(25)SEE2 to 5Mb, can someone provide me with links to where I need to look or possibly some short directions?...
I just recently set up a 7971 and the phone shows 'private' on all calls, internal and external. The same extension is on another phone and caller id works with that one so it leads me to believe it is something with the phone. I am using Software Ve...
I am implementing a new network and ip subnet where I work. The problem is that one User needs to have a static IP to our mother corporation but I cannot get the static NAT to work. My question is, will having this;nat (inside) 1 10.1.0.0 255.255.0.0...
Hi all, Im trying to set up a 6509 with a FWSM and am having some trouble. I have most of the config set up and working, I can ping from inside of the 6509 to a cisco 3750 that is connected on the outside with a L3 SVI with ip 192.168.113.10(represen...
Hi all, Im very new to configuring networking equipment (only been working with it for about 8 months) and I have been given a cisco 6509 with the fwsm to configure. The problem is I cant get it to work properly and was wondering if there was anywher...
Thank you, thats what I thought was going to be the problem. The 192.x.x.x addresses actually represent public addresses on the network where I work, we are trying to do a network migration to private addresses (10.1.x.x.) but would need to still be ...
I have a workstation sitting on the inside network with ip address 10.1.0.50. Is there a way to have NAT setup so that the internal computers can access outside networks but also be reachable from the outside?What Im saying is I dont want to have sta...
First let me say thank you, you have helped me figure a couple things out. Now for the next problem... I have Vlan 10 setup as a SVI since there will be routing between vlans on the inside of the network. Right now I have a Cisco 3750 switch with a l...
