I've read ad-nauseum about intra-interface routing when security-levels are the same. And I know that by default, traffic from a higher security level interface should flow without ACLs to lower security interfaces. I've read that enabling an ACL o...
It took me a while to get this information, so thought I'd share. Here it is:************You cannot use the upgrade tool to do the IOS to LWAPP for the 1250 APs. Here is a method to do the conversion.*Method 1 : ( Mode Button )*1. Install an externa...
Is it possible to limit which SSID's particular AP's broadcast? I've tried using AP Groups, but that only segments the VLAN broadcast domain. The AP still broadcasts all SSID's. I have 2 APs in a jury waiting room - I only want to broadcast their ...
Are there any "best practices" or recommended settings for optimizing voice traffic across a 1351 wireless bridge set? The 2 bridges are approx 200 feet from each other, no obstructions. Link tests from within the IOS show 1% retries and 54MB speed...
Hi - This is my first time using the 526 controllers. Here is the scenario: Two buildings connected via 1310 wireless bridges (one for voice, one for data). One building will have 6 521 APs, the other will have 1. I can't find documentation any w...
I just went through this with TAC. Don't know why, but during the join process, I was selecting the 'http' radio button (think I saw that in the documentation somewhere?). Each time it failed with the "No response" error. Once we left that box unc...
I had a little trouble following Vladimir's response, so I paid attention while the TAC engineer did his thing...Delete the server.* files as indicated in vlad's post aboveat CMD prompt opened as Administrator:C:\>net stop crmdmgtdThenC:\Program File...
Hello Jennifer - I did try what you suggested, but it did not work. Here's a summary of what we did to accomplish the objective:*******************************This configuration is what worked for our Security+ License enabled ASA:Our goal was to pu...
I agree. Sounds like you have too many access points for your area, and same channels and cells are overlapping. Your controller will adjust signal strength, but it can only go so low. If that lowest power setting still gives too much signal, you ...
