Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
<p>Hello,</p><p>There is a single connection between two 4500 switches.Switch A interface A - Switch B interface B</p><p>On switch A, the interface A is the only interface for an Etherchannel. On switch B, interface B does not belong to any Ethercha...
Hello,I wanted to only allow users to use interface command. But when I permit config terminal in ACS shell command set, all the commands are allowed. How can I limited the users to only have the permission for interfacce command?Thanks
Hello all,If I apply a 10 Mbps aggregate policer to one VLAN which belongs to two ports on one switch for inbound traffic, will the inbound traffic on the two different ports for the same VLAN will share the 10 Mbps bandwidth or under each port the ...
Hello,I am new to the wireless network. One of our customer request for the network usage information. I assume we can get the information from WCS like busiest AP report top 50 or radio report. Is this the correct information for the network usage? ...
We are using QinQ in customer edge switch and are planning to transmit the traffic over our MPLS core via EoMPLS. We use this command under the subinterface on the 10700 router: xconnect 2.2.2.2 200 enca mpls. Unfortuantely it doesn not work. The out...
Thanks for the quick response.I can see from the log information, the line protocol of the interface is down after it was removed form the Etherchannel. But it bounced back immediately.When the VLANs are added under the port-channel interface, they w...
Thanks for everyone.One thing I am note clear is that if I use enca dot1q vlan id under subinterface on the GSR, will the QinQ traffic be carried to the peer PE ? Or I have to use enca dot1q spvlan second-dot1q ce vlan-id to carry QiNQ traffic over M...
