Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I'm having a rash of phones that are refusing to power up. These are phones that have been in service for 2 years that were unplugged or rebooted for some reason and simply didn't power back up. They are fed from either a 3524XL-PWR or 4006 switch t...
I was updating the firmware on an ATA 186 when the power dropped, which rendered it comatose. I copyied the eeprom over from a working unit and it now works fine, except it also adopted the mac address of the other ata. Is there an easy way to chan...
I was just attempting to diagnose a problem pushing a particular <CiscoIPhoneExecute> xml tag to the phone. I was running a network sniffer on the PC port of my 7960 phone to watch the traffic and discovered something rather troubling.When you post ...
I'm trying to connect analog modems to FXS ports on a 3600 which routes the call out a T1. I can only get 22k connections and even those are pretty shaky. Faxes work fine going through the FXS ports.Does the 3660 support modem pass-through? What do ...
On all of our SG300-28P switches are doing this, the management interface is hanging sometime between a few hours to a few days after reboot. When this occurs the switch continues to function, but the management IP does not respond to pings, http or...
A translation rule/pattern would be the easy fix. Look for [2-9]xxxxxxxxx (ie, 10 digits not starting with a 1 or 0) and add the leading 1. You can also setup more specific rules. For example you can add add the area code for specific local exchan...
I did not realize the VG224 ran IOS. I thought it was the 24-port version of the VG248 which does not run IOS. Here is the software config guide for the VG224 http://www.cisco.com/univercd/cc/td/doc/product/access/vg/vg224/scg/index.htm. I believ...
I'm guessing your using Call Manager Express since you mention IOS. The changes are on the unit itself rather than in CM or the router running CME. I'm looking at my VG248 right now, which is the 48-port version of the VG224. If you telnet into the ...
I think we need some more details on your overhead paging system and what it requires. It may just be a jumper setting on the paging system for the line type. On the VG224, make sure you have the latest firmware as the early versions had some quirk...
