Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
HI,We are having an issue with intermittent flaps of our backbone link along with with some packet losses.We run OSPF on our core and EIGRP at the distribution level. Is there any way that we can implement a route dampening kind of feature, on the EI...
Hi, I was working with a issue, in which we were observing that the citrix application page is freezing intermittently for 5-10secs and again working without any discosnnections. On troubleshooting I did nt observe any abnormal latency or packet loss...
Hi,I was working with a issue, in which we were observing that the citrix application page is freezing intermittently for 5-10secs and again working without any discosnnections.On troubleshooting I did nt observe any abnormal latency or packet loss o...
Hi,I am planning for upgrade to a NP-225 to NPE-G2 on 7204 VXR router.I have also got 1 GB memory module.Can you pls guide me how to go about it in simple way.I am also not planning to remove the I/O controller card.
Hi, I just wanted to add a couple point and clarify a few thing before I go ahead.1. These citrix servers are internet facing and can be accesible from plain internet as well, and strangely that is giving better performance than the solution running...
Hi,The 2800 series routers are quite robust and will surely support 6 T1s.I have personally worked with 2841, that worked very well.But it also depends on what are the other overheads you are planning to put on the router, like will be running dynami...
Hi,I have got ur question but still iw ould need some clarifications.1. Ur internal users also wants to access the webserver using name to resolve from internal lan on which the webserver is... right ?2.Can u pls tell if users from exyernal are able ...
Hi,under this scenario............ use filters to define this.Now you can ideally have a access-router behind core WAN1 & WAN routers.here you can do is put route map on that router for say 172.16.1.10route-map permit 10match ip access-list 1set ip n...
Hi,Frgt to mention one thing this will only load share frward traffic.reverse traffic will not be load shared as your destination subnets are differnt.Pls note:As load sharing is by default.... ip load-sharing per destination.