Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Our network is looking at having to employ MD5 authentication for our EIGRP network to ensure no rogue routers can join our AS. However, we've never done it before, and we can't find anyone else around us who is doing it either. We don't know a lot a...
I have a site to site connection setup between an ASA 5510 and a PIX 501. I have the ASA's inside 10.1.1.x network being able to access the PIX's 10.2.2.x network. That is working fine. However, I need to be able to access both the ASA and PIX's outs...
I have an ASA 5520 that I need to access remotely via a dial up modem. Any configuration I need to do on the ASA to allow this? Can I use the console port as well as the AUX?
can someone explain the ramifications to existing production traffic going through a 4500 switch if the switch is made the root bridge for a specific VLAN? what sort of disruption am I looking at? I assume Spanning tree recalculates, but I've never t...
I have a need for our internet router to send syslog to a server on the inside interface of a PIX firewall. The internet router connects to the outside interface of the PIX. The interface on the router that faces the PIX has an ip of 5.5.5.5 and the ...
thanks for all your help. I was able to find the issue. I had to change the ip tacacs source-interface to the VLAN interface of the router, rather than its WAN interface. Not sure why, but that seemed to do it.
I don't know why I didn't think to look at the logs on the ACS. However, I just did and it comes up seeing the request as an "unknown NAS". I checked the network device group to make sure that this router was in it, and it is. I am using the LAN inte...
yes, I have that on. Strange this is that the switch on the remote end, which is directly connected to this router, does its TACACS just fine. I did a debug on the TACACS and attempted to login to the router, this is what it said.Aug 29 11:01:52.086:...
