Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi, the problem is sip is not registering.i have cisco ISR4321/K9 Cisco IOS Software, ISR Software (X86_64_LINUX_IOSD-UNIVERSALK9-M), Version 15.4(3)S7, RELEASE SOFTWARE (fc3)show run: voice service voip ip address trusted list ipv4 212.34.224.205 ...
What URL i need to enter in videoplayer to view multicast from codian VCR?I try quicktime and urls: rtsp://224.0.0.50:1234rtsp://224.0.0.50:1234/<addres of recording>I see multicast traffic in wireshark but how can i view it?
The problem was with NAT, on outside interface we have
ip nat outside
so we need to configure
voice service voip
sip
bind all source-interface "name of the internal interface"
after that sip registered succ...
Hi, again.
I try reload, but problem still the same.
then i update ios to last recomended version by cisco it's now
Cisco IOS XE Software, Version 03.16.06.S - Extended Support ReleaseCisco IOS Software, ISR Software (X86_64_LINUX_IOSD-UNIVERSALK9-M)...
Hi Jonathan,Tanks for reply.1. I don't try to reload but i'm planning this today maybe(it in production)2. Yes, it's coming from correct ip that i expected.3. No, no zone-based firewalls, just access lists but i check it and they not blocking anythin...
After all(cisco TAC), it is a bug.1. If in your webinterface you have "redirect http to https" checked, then you don't see multicast in player(or wait for the new release software).2. For h264 codec video start with big delay(about 7 minutes), you ca...
