Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Dear all,In previous LMS version, we could edit a list of commands that have to be excluded while comparing configuration.To do this select Resource Manager Essentials > Admin > Config Mgmt > Archive Mgmt> Exclude CommandsHow to do in LMS 4.1? (requ...
Dear all,We are implementing LMS 4.1 in place of LMS 3.2.I'm experiencing an issue with Fault Inventory, DFM is not functionning even if other services are OK. See belowWhen I check device info in DFM, I have:It is strange because SNMP is running for...
Hello.We are experiencing issue with some of our AP in HREAP mode. In fact, some users are not able to have a valid IP assigned when they are connected to the Wlan. the only solution I have to help them is to reboot the AP.It seems we have the proble...
I'm using ACS 4.2 and I defined in global Authentication Setup the EAP to use EAP-MSCHAPv2 and EAP-TLS.For some of my users I would like to put in place 802.1x on wired with EAP-TLS only. How to do to restrict EAP-TLS use only on a set of devices (Ci...
Michel,I found the solution. even if the ping was working, I just opened Firewall rules on Win 2008 server in order to allow ICMP requests/reply.Thanks,Yves-Alain
Hi,All of your prerequesites listed in the previous message are in place. The problem is after a undefined time, we are not ablt to log on ACS Admin Web Service. The only solution I have is to restart CSadmin service.When I did the test, the netstat ...
