Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
the ws-x6k-s2u-msfc2 is the standby sup engine and a ws-x6k-sup2-2ge is the primary. when removing the primary and starting to boot the secondary it hangs and goes to rommon but unable to type. if i place console cable into standby not able to type...
I managed to clear the boot system and now am stuck in rommon mode. there are limited commands there. I was trying to configure the 6500 to go to IOS from a ATA card but the transfer was only 33mb instead of the 52 of the 12.2(18)SXF9 software upda...
I've created a text file of the runnining-config for a 6500 in production that is running IOS and also a running config on a test 6500 running Cat OS and IOS. I've merged the two configs and ready to copy onto test and then place in production. Rec...
I pulled all blades out excluding the SFM2 and the X6516 but it was still unreadable. I had a 6548 and 6148a in the chassis simultaneously and they both ran fine. Also, I have only one PS in another 6500 chassis that houses several blades includin...
