Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hai we use cisco 4506 as access switches.I want to get all logging messages including interface up down status with the mac-address ..But i am not getting the logs for the interface up down status on 4506 switches..any specific configuration is requi...
Hai is it possible to get the log for port coming up & down on cisco 4500 & 6500 series switches....If so whether it is possible to see via console logging or telnet logging...I want to get log for every thing....Regards....Gokulakrishnan.
Hai this is gokulakrishnan , i want toknow whether there is any way getting any alerts when a new mac-addresses joined to our networks..we use 4500 & 6500 series catalysts...Regards...Gokulakrishnan.
Hi I have users of around 4000 in a building . They were configured for their project subnet and we have a guest network for the external users who come to visit their project people..We have to put them in a guest subnet where his access is restrict...
Hi,When i try to connect to a PSTN Phone behind PBX which is connected to my VoIP Gateway, i don't get a ring back. In the debug i see PI value 8 from the Router but i don't get SIP 180 Ringing. Instead i get SIP 183 SESSION PROGRESS. How to get the ...
I think when the log buffer is full at the switch then all the old logs will get accumulated at the Syslog server,..but i didn't specify any level in logging monitor" i have just configured " logging monitor " Is it not possible to monitor all events...
Hai i tried the above optionI given " terminal monitor " from privilege modei didn't get any logsi tried to configure " logging event link-status default " but i am not able to configure that from global config mode..There is no option for that...Reg...
HiI configured "logging synchronous " on line vty 0 15 & line con 0 also and seen the logs it doesn't show any logs about interface up down status....whether we need to give " logging synchronous level all " instead "logging synchronous " Regards.......
Hai i tried the above optionI given " terminal monitor " from privilege modei didn't get any logsi tried to configure " logging event link-status default " but i am not able to configure that from global config mode..There is no option for that...Re...
