After updating the firmware (upgrade rom-monitor filename bootflash), changing the boot system flash statements on the config to a newer code, and removing the old bootflash statement,  I reloaded the ASR 1001 router.  When the router recovered, it d...

I have been trying to plug in the different metrics (bandwidth, delay, reliability, load, and mtu) into the EIGRP metric formula, but have been unsuccessful at figuring out how it comes up with the composite metric. Here is the info I havedefault me...

I am getting "Token Ring is Reset" on my 3640 router. The router contains the following: S364CK9-12216 / Cisco 3640 Series IOS IP PLUS IPSEC 3DESMEM-3600-16U32FS / 16-to-32MB Flash Factory Upgrade for the Cisco 3600MEM3640-32U128D / 32-to-128 MB DRAM...

I have a router config (remote site) that contains a static route that I want to redistribute into eigrp (coming back to the host site), how do I make sure that that route goes through the VPN tunnel I have set up.

PRI on Cisco 3640 is rejecting the call from a 2610 router in a lab environment. Cause code 8095- call rejected. We are using a ADTRAN Atlas 550 as a PBX, but have determined (by the cause code) that the switch is fine, but for some reason the PRI r...