Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello everybody,Here is one scenario I found on the Cisco document (Please refer link below), which indicates that in 'Geographical redundancy' with load balancing we need to consider, FL-CUBEE-XXX-RED on "each" router. & not the Single-Use licenses ...
Usually, product/mfr part name start with CON means contract, e.g. Cisco refers it as smartnet for hardware & ESW for software support. 8X5XNBD is service level agreeement. Here it appears for CUCM business edition hardware support. HTH. AN
Hello,Which mode are you using for fax transmission ~ Fax pass-through or T38 fax relay mode?Have you tried capturing logs on the FW? Can you trace T38 packet drops if any? HTH, Regards,AN
Hello Marco,The scenario you explained has been depicted in detail in the document below.http://www.cisco.com/c/dam/en/us/td/docs/voice_ip_comm/expressway/config_guide/X8-5/Cisco-Expressway-Microsoft-Lync-Deployment-Guide-X8-5.pdf Hope this helps.Reg...
