Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello everyone, we have deployed a CCM at our main office and are using out p2p T1 for connectivity to our warehouse. The phones work fine and all VLANs are communicating just fine. We are running a 2811 router with a NM-ESW-16 module to handle switc...
Hello everyone. I am having a problem with my OWA access. I can access OWA with no problem from the internet. However, when I try to access it from the LAN I can't get to it. I have tried using the IP of the Echange server with no luck. Any help is a...
Hello everyone. We are going through our first installation of CUPS and are having some issues. We got is installed, but it fails the "peer validation" test with the CUCM. Here is the ecact error we are receiving.Failed to get trusted-peer validation...
We are trying to get smtp traffic passed into our mail server. Here are the commands that I issued. It is not working at all. Thank you for your help.access-list Outside_access_in extended permit tcp any eq smtp host 10.10.1.11 eq smtpaccess-group Ou...
We installed an ASA 5510 today and are having some problems. I can ping to the inside interface from my PC but can not get beyond that. From the ASA I can ping the outside workd no problem. Here is out config. Of course I removed our outside addresse...
Jason, thank you so much for your help. When I looked at the 'sh ip pim int' command I noticed that on the router that is local to the informacast server the voice sub-interface did not have the 'ip pim sparse-dense-mode' command applied. The command...
Yes, they are receiving 10.10.20.x addresses. The Informacast server is on the other side of the T-1 link and the RP address is the interface on the router at the other side.Jason
