Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Asking this out to the general Cisco community: I have a DHCP superscope setup on a Win2K3 server which is in the 209.180.X.X range. I moved it to a new DHCP server which is in the 192.168.X.X range. None of my clients could obtain an IP address. I c...
I've been troubleshooting this issue for about a week now. I have an Avaya one-X 9600 series phone which sits at connecting... The packet capture shows the phone request and registration confirmation, but I never get voice. The current port configura...
I have a WLAN configured with 18 1200 series AP's. I did a walkabout using the WLSE 2.7 for each floor individually. Since the walkabout I am experiencing intermittent connectivity issues. Either clients can't get a dhcp address or the signal strengt...
The problem was with the primary interface IP address being different from the DHCP scope. I had to enable the ip dhcp-smart-relay command globally and things now work just fine.The Secondary IP address is where I was trying to get the DHCP to answer...
Rick, thanks for answering my post. Here's some clarity on the issue:I moved DHCP scope 209.180.X.X from the server 209.180.X.X to a new server 192.168.X.X. I changed the ip helper address from 209.180.X.X to 192.168.X.X (new server IP).None of the c...
Thanks for your reply. I will look into installing these features from the CM cd's that I have.Will this act as an unattended call routing mechanism?I'd like for a caller to be able to call a number within my CM and have that number be directed to an...
Aaron, I am trying to configure my Call manager to allow callers to dial a specified number (on my CM server), get a dial tone and dial a different number.I'm not sure what this is called, but it's similiar to an unattended receptionist.Do you know i...
This issue is resolved. If anyone is experiencing this type of behavior, it is due to IOS release 12.3(2)JA. You need to upgrade to 12.3(2)JA.2 which resolves a mulicast/broadcast issue that severly impacts DHCP requests and acks.
