Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I'm trying to use a Call Consult Transfer to send a call to SIP trunk connecting to another voice system. My goal is to have the call transferred unless the other voice system is down (SIP trunk is unable to accept calls) then I would like the UCCX s...
You could integrate your sametime client with Unity Connection for voicemail notification and managementhttp://www.cisco.com/en/US/prod/collateral/voicesw/ps6789/ps5745/ps2237/product_data_sheet0900aecd8067a2ab.htmlCisco:"Cisco Unified Messaging with...
FYI > We've seen this before "hear dead air" on multicast from the CUCM when you haven't uploaded the music file to each server on the cluster (uploaded to each individual MOH server) - Unlike CM 4.x where media service references a shared folder.May...
rdianat,In Cisco terminology a DID/FXS card is actually 2 different separate features. When the card is configured FXS(default) it connects to edge station devices. But you can configure the VIC card to connect to the telephone carrier when you have ...
What version of VMWare are you running? - In virtual machines - you must meet the hard drive and memory guidelines set forth by the product requirements. I have found that 2GB is required to run CUCM in VMWARE. Try increasing your memory allocation t...
Yes you are correct - sounds like a fax server issue. If you remove the ATA partition from the CSS - do you still get the busy tone? = If you answer "yes" - then you are correct, an issue with the fax server.You mention that the fax server is an H.32...
