Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello. I'm looking for an oid that will give me the active RTP connections off an AS5400 being used as a VoIP to ISDN gateway. Basically, the same as the last line of output from "show voip rtp connections". Thanks,Mike
When using the 3560G in a top-of-rack type deployment, is it possible to group multiple gig ports to create a higher bandwidth trunk back to a cat 6509?
I'm currently running a 3640 at our corporate gateway, which generally works fine for our needs. Under the current configuration, the router uses about 40+% cpu peak. Lately I've been playing with nbar, and of course this really hammers the cpu when...
Is there any valid reason that "sh ip cef x.x.x.x" would yield results different from the output of "sh ip cef"?I have a situation where this is the case, and while the system should be using the path shown with "sh ip cef" it is actually trying to u...
I have a 7206VXR that I'm using to terminate some PPPoE ADSL sessions. I have recently added another DS3+Serial interface to this unit for terminating some backhaul traffic from another carrier. The problem I'm having is that I'm intermittently lo...
Thanks for the response. Yup. Looks like that's my solution. For anyone else who's interested, more info can be found here.http://www.cisco.com/en/US/docs/switches/lan/catalyst3550/software/release/12.1_14_ea1/configuration/guide/swethchl.html#wpxr...
Did this end up being an IOS issue? I'm going through the same thing with an NM-1A-T3 card right now in a 2811. However, I suspect there may be a newer card rev as this one was from a 3640.