Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have setup username as below in a cisco 3850.
username test privilege 15 secret 5 $1$UvXp$ddddd
But I cant ssh directly into priviledged mode goes to exec mode.
I have 2x3850 running in stack version-03.06.05E . 1 of the switch member rebooted.
I checked the crash dumps lot of info but dont know what to look for,any ideas?
I have 2x3850 switch in stack. One of the switch got removed from stack.
Current state of that switch is Removed.
Its running 03.06.06E.
I removed all the stack cables and reloaded ,shut down and connected stack cables again.But when it tries to syn ...
I have 2x3850 stack connected via fibre . But 1 link has gone not connected sometime back.
I did a shut/no shut on sw01 Te1/1/2 . It showed connected and then went down again.
sw01
Te1/1/2 sw03_gi1/1/1 connected trunk full 1000 1000Base...
There are 2 lines,issue is with sw1 so which one should i remove? What does removing this line do?
switch 1 provision ws-c3850-48t
switch 2 provision ws-c3850-48t
Another clarification.
I am using this firewall as internet wifi. So I want users to get captive portal login.
Nothing to do with administration of the fw.
Thanks aditya but also found this.
Captive Portal and Active AuthenticationIn order to provide better visibility in mapping users to IP addresses and their associated network events, the Captive Portal and Active Authentication feature can be config...
