Hi All,One of the two supervisors in an IOS 6509-E did not come back up after a power outage.  The failed supervisor in slot 5 was replaced and it booted successfully.  However, the supervisor in slot 5 only booted up to a "Cold" state.  I did notice...

Hi All,We are going to upgrade one of our remote site's 2811 router's WAN connetion from a fractioinal T1 to a full T1.  Since we have no TECH support at the remote site, I want to make sure all of my ducks are in a row for this upgrade.Can I do a "b...

Hi,I am a network newbie and got a question on FWSM (Version 3.2(7)).  Does the FWSM by default drops duplicate SYN packet on a TCP 3 way handshake?  The traffic is between the internal and external interface.Thanks,Network Newbie

Hi All,Network newbie need to verify all necessary services and protocols on a new WS-C6509-E are turned on.  This layer 3 switch will be used to connect to serversThanks!Cisco IOS Software, s72033_rp Software (s72033_rp-ADVIPSERVICESK9_WAN-M), Versi...

Hi,Network newbie here asking an embarrassing question on logging  We have a Cisco router with the following IOS version.  I want to enable logging; so do I need to configure event-log enable before adding the following logging configuration?Cisco 28...