Hi Jason,Feel free to give our Valcom Technical Support line a call at 800-825-2661. This setup has been tested in our lab, so I'm sure we can get it to work for you.Valcom Technical Support
(vendor reply)Typical reasons for registration failure could be a mismatch in the user ID or password used in the Valcom SIP paging unit with the User credentials created on the UCM. The following link goes to a configuration document on the Valcom ...
(Vendor Answer)Most of the Valcom paging controllers connect to loop-start trunk ports, so using an FXO port on the SPA8800 should work fine.Without knowing the model, it is difficult to say for sure. You can contact Valcom Tech Support at 800-VALCO...
Generally speaking, most Valcom units are designed for loop start trunk ports and will not work on an FXS port directly. Since you didn't mention the Valcom model (single zone, multizone, etc), I can't say if there would be a workaround to use thi...
The Valcom V-2001A will work with the FXO port using MGCP. Configuration instructions are posted on the Valcom website at http://www.valcom.com/techsupport/ip_solutions/config-guides.htm . The instructions should work for all of the Valcom page con...