Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
HelloWe have found the following issue configuring radius attributes for network access with packeteer appliances.With PAcketeer-AVPair attribute , value --> access=touch Login fails and we see thisPacketShaper# radius login user password"user" RAD...
Hi experts After upgrade to ACS 5.2 appliance , we are trying to configure AAA between Ciscoworks and ACS. Authentication is working but authorization fails , logged user cannot access to admin parameters. I've configured attributes manually but i...
HiI've several Lwapp ap monitor and I receive alarms in my WCS from some of them with these messages:%DOT11-6-DFS_TRIGGERED: DFS: triggered on frequency 5620 MHz%DOT11-6-DFS_TRIGGERED: DFS: triggered on frequency 5620 MHz%DOT11-6-DFS_TRIGGERED: DFS: ...
Thanks KarthikI read your document before to configure AAA for packeteer appliances and it was helpful . But problem persists , as I wrote vendor attribute is not delivered correctly by ACS to the packeteer.If I configure as vendor attribute : acce...
Hi In my case , I've solved my problems with this driver release9.0.2.31Date 19/07/2005In addition I found problems with new releases of Intel Prowireless software utilityWith version 9.0.2.1 it works fine, with upper versions there are problemsI hop...
Hi I recommend you to work with 1400 bridge antenna (dish, sector or omni). If you want a point to point link , then you can work with 2 dish antennas (3,5 Km is a small distance for this antennas)
