Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Scenario:Pure 3750X-48PS ip base stackOne switch reboots from a power issue (possibly the master switch? Haven't confirmed yet in the 3 cases I've seen)The rest of the stack stays running fine (as it should), the rebooted switch rejoins the stack jus...
Looking for feedback from other organizations that have large 3750 stacks. I've got one stack of (8) 3750's composed of (6) 3750G's and (2) plain 3750's. This particular stack is usually unresponsive to SNMP queries and often fails to write config ...
Anyone have this working with clients and appletv on anchored guest wlan? On 7.0.116.0 code with clients in same anchored guest subnet, airplay works fine just by enabling multicast on the 5508. But on 7.4 I can't seem to get that same scenario to ...
Just ran into this issue again on a 3750X 12.2(55) SE3 stack where the local IT person accidentally power cycled one of the switches in the stack. With one of the switches having booted at a different time from the others, cpu utilization during the...
Following up on my original post from some time ago:For the stack of (7) 3750E's that we needed to add one more to, we did go ahead with adding the 8th and have had no issues. For the other mixed stack of older 3750's, I broke that stack in half and...
I run into this all the time in Prime. Here's a brand new map with 2602 7.4 code AP's freshly placed. I have to recompute all of my new maps and some of my old ones. Would be nice if there was a global command to do that, or if the issue could be ...
This is definitely an issue with recent 1142 AP's tied to 4400 controllers (which can't go above 7.0 code). The LED will shut off after the AP fully boots on all my recent shipments. In my case the AP is working fine, just no LED which is a concern...
