About rvdsabu4life

rvdsabu4life · 08-26-2014

We recently upgraded all our 2960 switches to IOS 15.2. Now on all the switches, we get this alert a...

rvdsabu4life · 01-20-2014

I have a combination of Cisco 2960, 3560, and Aironet devices spanned over 4 locations. Is there goo...

rvdsabu4life · 01-15-2013

This was the problem. All working good now. Thanks!

rvdsabu4life · 01-08-2013

Also, neither of those commands fixed the issue

rvdsabu4life · 01-08-2013

This is the one that does not work. I have removed the IP addresses for security purposes

rvdsabu4life · 01-08-2013

Here is the one for the 1141. Currently the 1240 AP is at another location.Current configuration : 2...

rvdsabu4life · 01-08-2013

We just replaced our Cisco 1240 AP in one of our shops with a Cisco 1141 AP. This is not controller ...

rvdsabu4life · 05-23-2012

Just an update. I don't have any time left to try to get this working. I am going to buy an autonomo...

rvdsabu4life · 05-22-2012

Everything is correct and no p2p blocking is off

rvdsabu4life · 05-22-2012

When I run the "debug client" command, I get:Debug Flags Enabled: dhcp packet enabled. dot11 mobile ...

rvdsabu4life · 05-21-2012

Is the programming software a commercial product or produced in house. If it is a commercial product...

rvdsabu4life · 03-14-2012

Great thanks for the reply. I was worried I needed to find a 6 port POE lan controller.

rvdsabu4life · 03-14-2012

I bought 6 air-lap1042n-a-k9 for our business. They are mounted. I bought a Cisco POE switch for the...

rvdsabu4life · 04-25-2011

StarRouter#sh int trunkPort Mode Encapsulation Status Native vlanFa3 on 802.1q trunking 1Port Vlans ...

rvdsabu4life · 04-25-2011

After running "show ip int br | e una" both vlans are up.

Unable to collect sufficient entropy?