Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have configure Cisco access list (ACL) in Cisco router to permit access from subnet 10.203.128.0/24 to subnet 10.203.129.0/24 but only to host 10.203.129.254 not whole host of subnet. The configuration of my router like below
interface FastEthern...
I have problem while connecting Cambium Networks ePMP1000 Connectorized Radio AP with Cisco Catalyst Switch 3750/2960.
Before I connect Cambium Networks ePMP1000 Connectorized Radio AP into my corporate network in this case to Cisco Catalyst Switch 3...
We have problem when send email to tgi.co.id, when we check in Cisco IronPort C170 we found that domain tgi.co.id is down as we can see in the picture below
We also try to check with nslookup for domain tgi.co.id on the Cisco IronPort C170 and we fo...
Hello
So my access-list configuration will be like below correct?
ip access-list extended Net128_Inbound permit icmp 10.203.128.0 0.0.0.255 host 10.203.129.254 echo deny icmp 10.203.128.0 0.0.0.255 10.203.129.0 0.0.0.255 echo permit ip 10.203.12...
Hi Giuseppe,
When I try to create ACL for icmp echo-request parameter, its parameter command not available in my router only echo and echo-reply as shown below
RTR-JOB-PTJM-JKT(config-ext-nacl)#permit icmp 10.203.128.0 0.0.0.255 host 10.203.129.2...
Dear M.G. & all,
The option to install router in NGF site already executed and the result seem ok, thanks a lot to all for suggestion and attention for this issue.
Regards,
Perman
Hi Paul,
Many thanks for your attention, enclosed are configuration for switch and router in SKN site, unfortunately I have not yet configuration for L2 switch in NGF site because I am not have authorize to access this switch.
Best regards,
Perma...
