Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,I have a quick question regarding trunking with the ASA5510. Currently I have 3 switches (DMZ subnet /inside subnet/server subnet) connected to each GE port of the ASA. Our office/server subnet are the same but I'm looking to break that up. S...
Hello,We're in the process of ordering a 100mg circuit that will be handed off to us via fiber with LC fiber connectors. We're going to need to purchase a new router and wasn't sure which router would best handle the connection. At this time, we'll ...
Hello, I have a site-to-site VPN already established, everything is working as it should. I'm trying to block the remote network from accessing our network since we only need to access theirs. I'm sure this is something very easy to implement with ...
Hello,I was just looking for some advice or suggestions for which ISR router would fit our needs.Currently we have remote sites (MPLS) with about 5-10 users. Setup I have at each site is a Cisco 2811, 16 port card, with an E1/T1 VWIC. Another site ...
Hello Alain,Thanks for the reply. I'm not trying to use the ASA with 2 default routes, it only has one. I'm sure once you have time to go over my original post, you'll see what I'm trying to accomplish. Again, thanks for taking the time to review i...
Hello Alain,Not sure you if you can reply but I tried what you suggested and am running into minor issues. I think it has to do with the default route in my switch. Below is what I was originally trying to accomplish...GE 1/0 x.x.1.5 - server - curr...
Collin,Thanks for the reply. As of right now we utilize 15-20mg but I know that will go up since we're growing. For BGP, we would go partial and if came down to it, we can always upgrade the memory if we went to full routes. The BGP portion is st...
