Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I would not say that there is "Workaround: None" for this. We just installed a new 3540 WLC (anchor) to replace existing 2504 WLC. The SNMP Trap logs was filling up with "Failed to authorize AP with Base Radio MAC Authorization entry does not exist i...
We are upgrading to PRIME 3.1 (from 3.0.3), and have to start using Smart Licensing ...
What are the weights of tokens, for device types: unified access points, WiSM2 WLCs, WLC 2504, WLC 5500, WLC 8540 ?
From recommendations for Vo/IP QOS, the mtu=300 was used on a 3640 router serial interface at HQ, and also at the branch office 1751v router. HQ provides Internet access for the branch office, the branch office has a frame-relay conenction back to HQ...
Scenario: LA, NYC and SF will have 256K PVC frame-relay circuits to the customer's HQ in Upstate, NY (768K PVC.) They want to do data and voice over each PVC. Each branch office will have a new 1760 router, and there will be a 2600 at HQ. Occasionall...
We have found that any Mobility Express AP takes several minutes to boot. It is informative to login to the Console port and what the syslog messages. In our case we are wanting to create a standalone AP to be used for "AP on a stick" (APoAS) wireles...
Upgraded from 3.0.0.78 to PI 3.1.0, then immediately to 3.1.5. All of our version 1.x/2.x licensed were grandfathered (one-time) into PI 3.1.5. We are now doing Traditional licensing, within the Smart Licensing framework.
