Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Can we implement only SRST for IPP without CUCM,if we need only basic call fuction ? Because of the budget, so if we have enough budget can we install CUCM later for more function?
I used c3845 IOS 12.4 with fxs connect to analog phone. Why no busy tone in voice gateway router during line is busy ?Its like the fxs card or router not provide busy tone but for ring back tone is normal.
I used pri E1 with h.323, C3845 and CCM 6.0 after completed setup I tested call from PSTN to E1 number, I can't hear ring back tone but far site telephone ringing.After far site pick up ringing,he can not hear I talk but I hear he talk verything.Whi...
Thank you Scott.So, If I used "no keepalive" command under int fa0/0, interface and protocol will up both but I did not plug LAN cable into that interface.I also check with another new router C1841. After completed boot and no shutdown the fastEthern...
Thank very much for your advised. How about if I run one router as CME and another one for SRST ?or However,I need CUCM to register SRST router because CME can not register SRST.Thank you in advance.
