Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,Could you please look into my problem and say what is wrong with the ezVPN remote configuration?Set up is simple:ASA is the ezVPN server and 10.100.200/24 is the local net behind it.871 is the ezVPN remote with 10.10.10/28 behind it as a privat...
Hi there:)Cisco IP SLA has a feature Path-jitter.~~~~~~~~~~~~~~~~~~~~~~~~~~~~~router#show ip sla statisticsIPSLAs Latest Operation StatisticsIPSLA operation id: 1Type of operation: udp-jitter Latest RTT: 44 millisecondsLatest operation start t...
Hi there,I'm using Catalyst 3560 with c3560-ipservicesk9-mz.122-53.SE2.binIP SLA has been configured and works fine:~~~~~~~~~~~~~~~~~ip sla 1 path-jitter 172.16.1.4 source-ip 10.10.2.1 interval 300 request-data-size 1260 tag IP SLA PATH-Jitter MONITO...
Hi Federico,Hope all is well!Please review the thread and notice that 7 of 13 posts are yours and all of them are useless:)One suggestion for you. When you read the question be sure that you understand the question.When you are sure that you are comp...
Damn! Could you please stop spamming in this thread?Read carefully please:- thread's name is ezVPN remote, split tunneling doesn't work.- I wrote It's not a problem that ASA doesn't encrypt the packets back because I just did it as an experiment bec...
Hi Federico,The ASA is expecting the traffic from the remote to be 10.10.10.0/28 but you're NATing all traffic on the remote site to the public IP.Yeap, but keep in mind that remote is configured properly according to the configuration guide and exam...
I need to have working ezVPN remote.According to Cisco's documentation there is no need to configure NO_NAT & interesting ACLs on ezVPN remote manually, it gets this from ezVPN server.There is no NAT on ASA.Both running configs in my initial post.PS:...
Hi Federico,You didn't understand correctly:)The problem is 871 (ezVNP remote) doesn't encrypt the packets it NATs them.Configuration is almost the same as in the example from CCO and according to configuration guides it should work!But:~~~~~If I add...
