Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have the following topology: coresw>distributionsw>accesssw1>PtP WAP Bridge>accesssw2>routerVLAN300 is setup on the coresw and popultaes across to accesssw2 and i am able to ping DGW vlan 300 from every device on the network accept the router, this...
I am upgrading current circuits from T1 to T3. I'm trying to understand some terminolgy about the NM-1T3/E3. What does "Subrate T3/E3 with concurrent services" mean? Will the card support the full T3 signal from the Telco but only at a subrate 9Mb...
I have been successful establishing a tunnel with a client using a Bintec router, they are the initiator of the tunnel. The problem I am having is getting their back dsl connection to work when the primary fails. There primary connection and second...
I am using a 3005 and Aironet 1200. When I use these 2 together I am not able to login to my novell server, I am not able to ping the server either. If use one or the other of these technologies alone I have no problems but when I use them together...
This is POP server used for relaying. fixup smtp is not disabled and there have been know chnages on the PIX. I came across this problem while helping one the server admins troubleshoot a problem with the server.
Will this pass channel traffic? What I want is to pass channel traffic from the IBM mainframe to channel attached printers on the otherside of the WAN link. You'll have to excuse my inexperience here but this is the best way for me to explain what ...
Yes, I can ping from the ld to the reals and when I did ping again from the ld the addresses showed up in the sh arp on e1.Yes, the vlans in question are correct and both are forwarding.Thanks,Todd.
