Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,I have a question about how to influence the routes learned from a specific EIGRP neighbour. We have one multi-access vlan with 2 core switches and 2 routers. Switch A and Switch B have the same routes (shared VLANs). Router A and Router B have al...
Hi,We are on the verge of buying a pair of N7Ks with FabricPath enabled modules. There are still a few questions we did not get answered,yet.1. Can we create and route VLANs between 7Ks when we only have the F248XP-25 modules installed ?2. When do we...
When readinghttp://www.cisco.com/en/US/docs/switches/datacenter/nexus5000/sw/mkt_ops_guides/513_n1_1/n5k_enhanced_vpc.htmlFigure 6-1I have a few questions about "Figure 6-1 Enhanced vPC Topology" when upgrading the N5K with the DH FEX Configurati...
Hi,We have a /28 on the outside and want to assign seperate IP addresses with NAT to seperate VRFS, for example:130.140.131.78 -> NAT -> vrf A -> 192.168.1.1130.140.131.79 -> NAT -> vrf B -> 192.168.1.1on so on and so forth....Is this possible ? I ha...
All the problem is that the setup is that both Switch A and B are in the same VLAN connecting to routers A + B.EIGRP-IPv4 Neighbors for AS(10)H Address Interface Hold Uptime SRTT RTO Q Seq ...
Hi, I have a similar problem since the upgrade to 6.2.2.Cisco Nexus Operating System (NX-OS) SoftwareTAC support: http://www.cisco.com/tacDocuments: http://www.cisco.com/en/US/products/ps9372/tsd_products_support_series_home.htmlCopyright (c) 2002-2...
