Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Is there a specific message/string/tell-tale in the CUCM log files for when an attempt is made to set up a call on a PRI but all channels are already full?In CUCM 5.x, the string to look for is "Locations_updateLocationTblEntry_RELEASE_BANDWIDTH" fol...
I'm having trouble identifying where and how certain metrics are arrived at on my network and was hoping someone may have some insight. I was unable to get to the bottom of it with TAC.I've got a L3 MAN environment with 3 WAN aggregation routers spr...
A follow up question to that posted by a user on May 3rd, 2009.On my 2621XM that uses DHCP to obtain an IP addresss from my ISP, I have a reflexive acl that allows all inside-originated traffic out and responses back in.I do successfully obtain an IP...
I'm trying to prove that a disruption in service a few days ago was due to all our PRI channels being in use. Symptom to users was fast-busy when trying to place calls.We did have full tracing turned on while the disruption occurred. I've collected...
I've got a 2801 MGCP gateway with a VWIC2-1MFT-T1/E1 configured as a PRI and using bottom-up channel selection.All 23 channels are administratively up. The first call is successful and used channel 23.When channel 23 is in use I can see subsequent c...
Hi Rick.You nailed it!I was able to find a specific route with that delay, bandwidth, and hop count. It is coming from yet another WAN aggregation router that was deployed without the summarization (which I'm trying to correct) and therefore was lea...
Closer reading indicates that the space is needed on the "common" partition - not the active or inactive partition, in which case I have enough disk space to proceed with the upgrade from CUCM 5.1(2a) to 5.1(2b).
It seems that clearing that dynamic CAM table has removed all the excess entries. So far they haven't come back. I'm still curious as to what would have caused them to be there in the first place....
I haven't seen BW on LMI types other than Cisco (though my sample size is small), but it is true I have some circuits that use Cisco LMI and BW does not show up, even though the frame-relay provider has assured me that the CIR is there.If the BW come...
Here is an example:Serial2/3 (up): ip 192.168.10.50 dlci 56(0x38,0xC80), static, broadcast, IETF, BW = 16000, status defined, activeThe "BW = 16000" is the CIR on the given PVC. It isn't related to encapsulation, so I think...
