Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have been seeing drops on my port facing my WAN lately. We have a 50mbps pipe going out. I realize the port is set to 100 (hard set for ISP device) but I would think the drops spiking over 50mbps would be on the ISP's equipment. QOS is enabled on t...
I'm trying to setup VPN users to authenticate with digital certificates as part of 2 factor authenication. With a 5510 (upgrading to 5515) with access to Microsoft 2008r and 2012, Which would be a better fit the Microsoft service or the built-in CA s...
4510 info:License Information for 'WS-X45-SUP7-E'License Level: entservicesVersion 03.03.01.SG RELEASE SOFTWARE (fc2)I have a packet shaper on one of my ports that connects to our service provider for all our remote branches. 13.5 mpbs is dedicated t...
I am trying to configure new 4510 (SUP7-E, License level:entservices) core switch for qos and I am having difficulty in finding the command migration from Version 12.2(31)SGA4 to Version 03.03.01.SG 15.1(1)SG1. We use ShoreTel for our VoIP solution, ...
I have a Newly addedCisco 881 connected to a firewall, which is connected to DSL. We added it for wireless and when wireless clients connect to the network (using standalone APs) they are able to ping everything on the 192.168.88.0 network. They can...
I appreciate the help. I'll probably do a combination of moving to the SFP ports and adding the SRR commands. We have them applied on ports to the end users but not on the Metro line it's self.
Yea, The traffic vs. drops may not be abnormal. When I first looked into shaping on the 3750 I read that shaping wasn't supported only queuing and congestion avoidance. (not sure the fine line between queuing and shaping). I am looking into the uplin...
If I can remember, it copies everything over at bootup (the whole config file). I'd recommend hard setting a master for the slaves instead of letting it decide. you can view with a show switch. I believe set the priority for the master is:switch stac...
