Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
When a phone is on the voice vlan packet destined for it should have a 802.1q tag with a VLAN ID of the voice vlan. Does the EAP packet (for the phone) have an 802.1q vlan header when using 802.1X MDA? What about re-authentication packets? The Standa...
When a phone is on the voice vlan packet destined for it should have a 802.1q tag with a VLAN ID of the voice vlan.Does the EAP packet (for the phone) have an 802.1q vlan header when using 802.1X MDA? What about re-authentication packets?The RFC says...
I have a PE to CE connection via GRE tunnel with IPSec. When traffic comes from another remote PE (via a tag'ed link) I recive an error message "%CRYPTO-4-RECVD_PKT_INV_IDENTITY: identity doesn't match negotiated identity". (ip) dest_addr= 99.99.9...
What level are they migrated to? Basic or Enhanced? How do I obtain the additional DLUs for Cisco Mobility (SNR)? Cisco TAC will not do anything without a sales order.
I have the same question. I agree the "backend" will still use DLU. You will get the exact number of DLU required to run the phones you have. However, how do I enable SNR for all users? That is a feature that is included in all levels of UCL, but req...
OK it looks like this. I am setting up two head end routers (for redundancy) to terminate connections from customers. These customers could have overlapping addresses. My design was to use MPLS/VPN to connect these customers as CE’s to avoid overl...
I would think that your remote site (router2) would advertise it's local routes over the ISDN when dialed up. And if the connection is broken (not reciving routes over the VPN) then the only route for Router1 to the remote site would be over the ISD...
