Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi all,although I've seen suggestions against modifying the default values for this command, I've come across a situation in which it seems to help a lot to increase the parameter "interrupt-time" associated with fast switching.Basically, although th...
Hello,according to some documentation that command is supported on IOS 12.2(4)T. However, I installed version 12.2(5)d in a 2621 router and is not there. I presume it is because the feature set?How can I relate a command accurately with a feature set...
Hello,I'm using the "show ip route command" to display specific information about the network shown. See below:Router#sh ip rou 193.113.238.18Routing entry for 193.113.238.16/29 Known via "ospf 100", distance 110, metric 51, type intra area Last up...
Hi,check this reference which points out differences between the two cards.http://www.cisco.com/en/US/products/hw/routers/ps221/products_data_sheet09186a00801a9184.htmlYou should be fine with support of this card in the 2600XMs.Check the document for...
Hi Toyin,if you are connecting to a laptop you should be using a cross-over cableCheck this reference:http://en.wikipedia.org/wiki/Ethernet_crossover_cableas In the other two cases, (2950 and 3750) you should be using a straight through cable.These p...
Hi,BGP uses update messages (different to periodic keepalives) to exchange prefix/attributes information just after session establishment or when a topology change/updates occur. In that sense there are no "periodic" updates (hence timers) to control...
I've got the same problem with a 3620 router. When a sh ver is given there is no indication of this flash card being a ATA disk. Here the output in the router: 16384K bytes of processor board System flash (Read/Write)20480K bytes of processor board P...
